V. 3 Does not work in Catalina

Completely free iSCSI initiator software for Mac OS X.
Post Reply
Birdwaves
Posts: 3
Joined: Wed Feb 26, 2020 7:33 am

V. 3 Does not work in Catalina

Post by Birdwaves » Mon Apr 27, 2020 12:13 pm

I add "Portal" , close, then.... nothing.

Nothing appears under target name.

Olivia (staff)
Posts: 205
Joined: Thu Nov 05, 2009 5:52 pm
Contact:

Re: V. 3 Does not work in Catalina

Post by Olivia (staff) » Tue May 05, 2020 8:15 pm

Hello ,

The problem is mostly because kernel extension can't be loaded due to system prolicy.
If you do not deny the kernel extension during installation, you could go to "Security & Privacy" preference panel, there is prompt button to ask load the kernel extension of iSCSI initiator, press the Allow button, then you will be able to use.

User can also run the following command to troubleshot:
sudo kextutil -v 6 /Library/Extensions/KScsiPrt.kext
After run the above command, the kext will be loaded or appear in the "Security & Privacy" preference panel to ask user to "Allow".
KernSafe Support Team
iSCSI SAN, iSCSI Target, iSCSI initiator and related technological support.
[email protected]

Post Reply